Product Description

Please check your required option:

Version P (Position Feedback): It can be controlled by the optional LAC board or any suitable Motor Controller with analog feedback input
Version S (with End Switches): Has embedded internal end position switches which switch off the power 1mm before end is reached. Power can then be reversed due to internal diodes.(available on special order only)

The L16 Linear Actuator is an axial design with a powerful drivetrain and a rectangular cross section for increased rigidity.

The L16 actuator is designed to move push or pull loads along its full stroke length.
The speed of travel is determined by the gearing of the actuator and the load or force the actuator is working against at a given point in time.
When power is removed, the actuator stops moving and holds its position, unless the applied load exceeds the backdrive force, in which case the actuator will backdrive.
Stalling the actuator under power for short periods of time (several seconds) will not damage the actuator.

The linear actuator is an alternative to designing with gears, motors, servos and linkages.

It can accept 12V DC voltage, cable length is 30cm

Comes packaged with:

• Two mounting clamps
• Two mounting brackets
• Two rod end options: a clevis end and a threaded end with nut

Controllers

This linear actuator can be used with all motor controllers or direct DC Voltage up to 12V