Phidgets DCC1002_0 4A DC Motor Phidget

SKU: 23184

Category: Motors & Controls

Available immediately
Delivery time: 8 - 9 Workdays (DE - int. shipments may differ)

60,69 €

incl. 19% VAT , plus (Warenpost)

Control a single DC motor up to 4 A with this compact and affordable phidget. Connects to a VINT connector.

Description
Reviews

Phidgets DCC1002_0 4A DC Motor Phidget

The DCC1002 gives you complete control of a brushed DC motor up to 4 amps. It offers a compact, enclosed design that makes it easy to fit into smaller projects. This phidget connects to your computer via a VINT hub.

Features:

Controls motor speed, acceleration, and braking force -Forward and reverse.
Set a specific target position (requires an encoder).
Encoder input - Read the quadrature signal from an encoder attached to the motor shaft. This allows you to create a closed loop position controller.

Technical details:

Isolation - The VINT connector of this device is isolated, which increases reliability and prevents ground loops.
Polarity protection - The device will not turn on and will not be damaged if the power supply is connected backwards
Overcurrent protection - Built-in fuse to protect the controller in case of overcurrent
Overheat protection - Built-in heat sink prevents overheating
Failsafe protection - Set the unit to turn off automatically when your program stops responding.

Specifications:

Board Properties	Controlled By	VINT
Controller Properties	Motor Type	DC Motor
	Number of Motor Ports	1
	Acceleration Min	0.1 % Duty Cycle/s
	Acceleration Max	100 % Duty Cycle/s
	PWM Frequency	25 kHz
	Sampling Interval Min	100 ms/sample
	Sampling Interval Max	60 s/sample
	Acceleration Resolution	0.1 Duty Cycle/s
	Velocity Resolution	0.001 Duty Cycle
	Current Limit Resolution	5.6 mA
	Acceleration Time Min	20 ms
	Acceleration Time Max	20 s
Electrical Properties	Continuous Motor Current Max	4 A
	Supply Voltage Min	8 V DC
	Supply Voltage Max	30 V DC
	Current Consumption (Unconfigured)	(VINT Port) 500 μA
	Current Consumption Max	(VINT Port) 2 mA
	Power Consumption (Unconfigured)	288 mW
	Power Consumption	motor power plus 700 mW
	Replacement Fuse	5A Slow Blow Blade Type, Standard or Micro
Encoder Interface	Number of Encoder Inputs	1
	Encoder Interface Resolution	x4
	Count Rate Max	400000 pulses/s
	Sampling Interval Min	50 ms/sample
	Sampling Interval Max	60 s/sample
	Encoder Input Low Voltage Max	2.4 V DC
	Encoder Input High Voltage Min	2.6 V DC
	Time Resolution	1 μs
Physical Properties	Recommended Wire Size	16 - 26 AWG
	Operating Temperature Min	-40 °C
	Operating Temperature Max	85 °C