Phidgets ENC4107_0 Draw Wire Encoder 1.5m Draw Wire Encoder Measuring length of exposed wire with spring Mounting with M5 Screw

SKU: PHI-ENC4107_0

GTIN: 4251326831212

Category: Other Electronics Accessories

Available immediately
Delivery time: 8 - 9 Workdays (DE - int. shipments may differ)

270,99 €

incl. 19% VAT , (DPD)

Like a digital tape measure, this 1500mm long draw wire encoder measures the length of the wire that is pulled out.

Description
Reviews

Phidgets ENC4107_0 Draw Wire Encoder 1.5m Draw Wire Encoder

In complex mechanical systems, it is often very difficult to accurately measure the motion of a single part, especially when it has multiple degrees of freedom. The Draw Wire Encoder is a versatile solution to this very problem. It can be attached to a part with an M5 screw or attached to the end with a cable tie, and the encoder itself has a pair of M5 threads on the back for easy installation.

When the wire is pulled out, the sensor generates a quadrature signal that describes the length of the exposed wire. The coil is spring-loaded, meaning it retracts when the wire is no longer under tension. Multiple wire pull sensors can be used to track position in more than one dimension.

Connection:

This quadrature encoder can be read from an encoder interface by attaching the appropriate connector to the end of the cable. See the Connection and Compatibility tab for more Information.

Encoder Properties	Manufacturer Part Number	RLC50D-1500-D1F-1M
	Output Circuit Type	Push-Pull
	Length Resolution	100 μm/cyc
	Wire Pull Length	1.5 m
Electrical Properties	Supply Voltage Max	5 V DC
	Current Consumption Max	60 mA
Physical Properties	Wire Load Maximum	255 g
	Wire Pull Speed Max	1 m/s
	Weight	485 g
	Operating Temperature Min	-30 °C
	Operating Temperature Max	90 °C
	Screw Thread Size	M5
	IP Rating	IP54